This project was one third of a "measure, mark, cut" assignment we had been given. This prototype represents a concept I had for the 'cut' requirement.

Basically, an ordinary saw blade set with an adjustable connecting shaft. This item could be used to trim otherwise unreachable branches and foliage from trees. The handle featured a form fitting grip and a secondary handle for extra stability. The shaft itself was a sqaure drive shaft which enabled the length to be adjustable. The motor drive and controls would be located in the base of the unit.

The model shown was made from a wooden dowel, metal cylinder, saw blade, plaster and rubber grip (shaped to form) and miscellaneous materials.